FUJITSU DL9300 - Manual (Page 60)

User's Manual
Paper
Handling
PAPER HANDLING
3-3
Table 3.1 Buttons Used for Paper Handling
Button Purpose Action
Change the
printer mode
Stop/resume
printing
Load/unload
paper
Save adjusted
load point
Form feed
Line feed
Advance forms
for tear-off
Selects paper
path
Set/reset multi
copy mode
Select cut sheet
ejection
Micro Feed
ONLINE
LOAD
LF/FF
TEAR OFF
PAPER
PATH
MULTI
COPY
FRONT
DIR
↑
MICRO
↓
MICRO
Press ONLINE to place the printer online or offline.
Press ONLINE to stop or resume printing.
Press LOAD to load paper or to retract continuous
forms to the “park position.”
Press LOAD and ONLINE to permanently store the
load position adjusted by micro feeding.
Press and hold LF/FF to execute a form feed.
Continuous forms are fed forward by one page.
Single sheets are ejected.
Press LF/FF within three seconds to feed paper
forward by one line.
Press TEAR OFF to advance the forms perforation to
the tear-off edge. Tear off the forms, then press any
button to retract remaining the forms.
Press PAPER PATH to select the paper path: front
tractor, rear tractor, cut sheet.
Press MULTI COPY to set or reset multi copy mode.
Select a direction of ejecting cut sheet.
• Front ejection – FRONT indicates
• Rear ejection – FRONT does not indicate
When you save your setting in the setup mode, it
becomes the new default. The default setting is
invoked whenever you turn on the printer.
Press
↑
MICRO/
↓
MICRO to feed paper by 1/180
inch in the direction of the arrow.