FUJITSU DL9300 - Manual (Page 156)

User's Manual 7-3
Trouble- shooting
TROUBLE-SHOOTING
Table 7.1 Print Quality Problems and Solutions (Cont.)
Problem Solution
Printing is Use the printer’s V-ALMNT function to
vertically check the vertical print alignment. If necessary,
misaligned adjust the print alignment. See the section
(jagged). Using the Diagnostic Functions in Chapter 5.
The top margin is The top margin is the sum of the top-of-form
wrong.
setting, the software-specified top margin, and
the printer’s TOP-MRG setting. Proceed as
follows:
• Make sure that the top-of-form setting is
correct. The factory default is 25.4 mm (1
inch). See the section Changing Top-of
Form
in Chapter 5.
• Check the software-specified top margin.
Refer to your software documentation.
• Check the printer’s TOP-MRG setting. See
the section MENU1 and MENU2 Items and
Options
in Chapter 5.
Lines are double Check the line spacing setting in your software.
spaced instead of
single spaced.
Change the CR-CODE setting in the printer
setup mode to CR ONLY. See the section
MENU1 and MENU2 Items and Options
in
Chapter 5.
The printer Change the CR-CODE setting in the printer
overprints on the setup mode to CR & LF. See the section
s ame line. MENU1 and MENU2 Items and Options in
Chapter 5.
The next print line Change the LF-CODE setting in the printer
starts where the
setup mode to LF & CR. See the section
previous line MENU1 and MENU2 Items and Options in
ended instead of Chapter 5.
at the left margin.