FUJITSU DL9300 - Manual (Page 96)

Setup Mode
USING SETUP MODE
User's Manual 5-5
Table 5.1 Setup Mode Functions (Cont.)
Function Purpose
DEFAULT Resets factory defaults in MENU1 and
MENU2.
LIST Prints a list of all currently selected options.
SELF-TST Runs the self-test.
HEX-DUMP Prints hex dumps.
V-ALMNT Checks and corrects vertical print alignment.
To select a function from the <> menu:
1. Repeatedly press the “
←
” or “
→
” button to position the red
cursor on the plastic print guide under the function you require.
2. Press the “
↑
” button or the “
↓
” button to select the function. If
the function has items and options, the printer prints the first
item and its options. The MENU1, MENU2, HARDWRE,
ADJUST, CONFIG, and GAP-ADJ functions contain items that
have selectable options. The other functions have neither
items nor options.
The first three MENU1 items and their options are shown
below. Items are enclosed in single brackets < >.
DPL24C+ XL24E ESC/P2
COUR 10 PRSTG12 COMPRSD BOLDFCE PICA 10 CORRESP OCR-B
OCR-A COUR-N COUR-B COUR-I N.SAN-N N.SAN-B N.SAN-I
TIMLS-N TIMLS-B TIMLS-I DOWNLD0 DOWNLD1
LETTER REPORT DRAFT