FUJITSU DL9300 - Manual (Page 120)

Setup Mode
USING SETUP MODE
User's Manual 5-29
Table 5.4 HARDWRE Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
HARDWRE
Items
Options Description
NOTE:
(continued) • 0BYTE option is recommended
only for graphics application.
• With 96KB selected, the printer
cannot accept any download font
data.
N/C: Does not out put +5V to pin 18 of the
Centronics cable.
+5V Outputs +5V to pin 18 of the
Centronics cable.
Selects the type of the interface to the
computer.
PARALEL Centronics parallel interface
SERIAL RS-232C serial interface
AUTO-2S Auto interface selection mode
AUTO-4S Both interfaces are ready for
AUTO-6S communication.
AUTO10S Specify the timing of regarding the
AUTO15S selected interface as being inactive.
AUTO20S
Serial Interface Items. The following to
items are not printed when you select the PARALEL option for the
item. Be sure that the options selected on the printer
are the same as the options selected using your computer operating
system or your software. Refer to the documentation provided for
your computer and software.
Number of Number of
data bits Parity bit stop bits
8NONE 1 8 None 1
8NONE 2 8 None 2
8EVEN 1 8 Even 1
8ODD 1 8 Odd 1
7EVEN 1 7 Even 1
7ODD 1 7 Odd 1
7MARK 1 7 Mark 1