FUJITSU DL9300 - Manual (Page 95)

USING SETUP MODE
User's Manual 5-4
The initial printout contains a header, help menu, and <TION>> menu. The header tells you that the printer is offline and in
setup mode. The help menu provides a quick summary of how to use
setup mode. The <> menu lists all of the functions
available to you in setup mode. Note that the red cursor on the plastic
print guide is initially positioned below the SAVE & END function.
Setup mode can also be entered by turning off the printer, then
turning the printer back on while pressing the
↑
MICRO and
↓
MICRO
buttons simultaneously until the printer beeps.
When you enter setup mode, the following <> menu is
printed: OVERVIEW OF SETUP MODE
<>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT
LIST SELF-TST HEX-DUMP V-ALMNT GAP-ADJ
Table 5.1 summarizes the purpose of each function.
Table 5.1 Setup Mode Functions
SAVE & END Exits setup mode and saves any changes made
while in setup mode.
MENU1 and Assigns print features to MENU1 and
MENU2 MENU2 on the printer control panel.
HARDWRE Changes the printer hardware options.
ADJUST Changes the print position adjustment options.
CONFIG Changes the configuration options.
GAP-ADJ Adjust the gap between the print head and
printing paper.
Function Purpose