Unloading continuous forms, Tearing off continuous forms – FUJITSU DL9300 User Manual
Page 80
User's Manual
Paper
Handling
PAPER HANDLING
3-23
Unloading Continuous Forms
To unload continuous forms:
1. Make sure that the FRONT TRACTOR or REAR TRACTOR
indicator lights.
2. Press the LOAD button. The continuous forms paper is
retracted to the park position. If the paper cannot be retracted
in one operation, continue to press the LOAD button until the
paper is parked.
NOTE
The printer can retract continuous forms paper a maximum of
55.8 cm (22 inches) per o
peration.
3. To remove the paper, raise the tractor paper holders and lift out
the paper.
NOTE
If continuous forms are unloaded without stopping, the paper
may slip off the tractors.
Tearing Off Continuous Forms
Your printer has a special “tear-off edge” that allows you to tear off
printed pages without wasting paper. The tear-off edge is located on
the front and rear of the printer.
To tear off continuous forms using the tear-off edge:
1. Press the TEAR OFF button. The bottom perforation of the last
page advances to the tear-off edge. If you specified TEAR OFF:
AUTO using the HARDWRE function in setup mode, the paper
automatically advances to the tear-off edge at the end of each
job (or when the printer has printed all the data received).