ABAQUS Volume II: I–Z User Manual
Page 50
*INCIDENT WAVE PROPERTY
4. X-component of
, the velocity of the incident wave standoff point.
5. Y-component of
, the velocity of the incident wave standoff point.
6. Z-component of
, the velocity of the incident wave standoff point.
Second line:
1. X-coordinate of
, the position of the incident wave source point. Alternatively, specify the
name of an *AMPLITUDE definition describing the time history of this coordinate.
2. Y-coordinate of
, the position of the incident wave source point. Alternatively, specify the
name of an *AMPLITUDE definition describing the time history of this coordinate.
3. Z-coordinate of
, the position of the incident wave source point. Alternatively, specify the
name of an *AMPLITUDE definition describing the time history of this coordinate.
If TYPE=PLANE, the vector from
to
defines the direction of the incoming wave; the distance
between the two points is unimportant. For incident wave loads using bubble amplitudes, the source
positions defined by the user with the *INCIDENT WAVE PROPERTY option are interpreted as
the initial positions of the source.
9.12–2
ABAQUS Version 6.1
Module: ID:
Printed on: