Fortinet 100A - Manual (Page 353)

Log & Report fortilog setting
FortiGate-100A Administration Guide 01-28007-0068-20041203
353
get log fortilog setting
show log fortilog setting
Example
This example shows how to enable logging to a FortiLog unit, set the FortiLog IP
address, add a local ID, and add a pre-shared key for an IPSec VPN tunnel.
config log fortilog setting
set status enable
set server 192.168.100.1
set localid net_host_c
set psksecret J7fram54AhTWmoF5
end
This example shows how to display the log setting for logging to a FortiLog unit.
get log fortilog setting
This example shows how to display the configuration for logging to a FortiLog unit.
show log fortilog setting
If the show command returns you to the prompt, the settings are at default.
log fortilog setting command keywords and variables
Keywords and
variables Description Default Availability
encrypt
{enable | disable} Enter enable to enable encrypted
communication with the FortiLog unit.
disable All models.
localid Enter the local ID for an IPSec VPN tunnel
to a FortiLog unit. You can create an IPSec
VPN tunnel if one or more FortiGate units
are sending log messages to a FortiLog
unit across the Internet. Using an IPSec
VPN tunnel means that all log messages
sent by the FortiGate are encrypted and
secure.
No
default.
All models.
psksecret
Enter the pre-shared key for the IPSec
VPN tunnel to a FortiLog unit. You can
create an IPSec VPN tunnel if one or more
FortiGate units are sending log messages
to a FortiLog unit across the Internet. Using
an IPSec VPN tunnel means that all log
messages sent by the FortiGate are
encrypted and secure.
No
default.
All models.
server
Enter the IP address of the FortiLog unit. No
default.
All models.
status
{disable | enable} Enter enable to enable logging to a
FortiLog unit.
disable All models.
Note: The IPSec VPN settings for the FortiGate unit must match the VPN settings on the
FortiLog unit.