Fortinet 100A - Manual (Page 20)

20
01-28007-0068-20041203 Fortinet Inc.
Secure installation, configuration, and management Introduction
You enter:
execute restore config myfile.bak
indicates an ASCII string that does not contain new-lines or carriage
returns.
indicates an integer string that is a decimal (base 10) number.
indicates a hexadecimal string that uses the digits 0-9 and letters
A-F.
indicates a dotted decimal IPv4 address.
indicates a dotted decimal IPv4 netmask.
indicates a dotted decimal IPv4 address followed by a dotted
decimal IPv4 netmask.
indicates a dotted decimal IPv6 address.
indicates a dotted decimal IPv6 netmask.
indicates a dotted decimal IPv6 address followed by a dotted
decimal IPv6 netmask.
• Vertical bar and curly brackets {|} to separate alternative, mutually exclusive
required keywords.
For example:
set opmode {nat | transparent}
You can enter set opmode nat or set opmode transparent.
• Square brackets [ ] to indicate that a keyword or variable is optional.
For example:
show system interface []
To show the settings for all interfaces, you can enter show system interface.
To show the settings for the internal interface, you can enter show system
interface internal.
• A space to separate options that can be entered in any combination and must be
separated by spaces.
For example:
set allowaccess {ping https ssh snmp http telnet}
You can enter any of the following:
set allowaccess ping
set allowaccess ping https ssh
set allowaccess https ping ssh
set allowaccess snmp
In most cases to make changes to lists that contain options separated by spaces,
you need to retype the whole list including all the options you want to apply and
excluding all the options you want to remove.