Fortinet 100A - Manual (Page 182)

182
01-28007-0068-20041203 Fortinet Inc.
config router ospf Router
hello-interval
The time, in seconds, between
hello packets.
All routers on the network must
use the same value for
hello-interval.
The valid range for
seconds_integer is 1 to
65535.
10 All models.
interface Enter the name of the interface
to associate with this OSPF
configuration.
No default. All models.
ip Enter the IP address of the
interface named by the
interface keyword.
It is possible to apply different
OSPF configurations for
different IP addresses defined
on the same interface.
The IP address 0.0.0.0 is not
allowed.
No default. All models.
md5-key
Enter the key ID and password
to use for MD5 authentication
You can add more than one
key ID and key pair per
interface. However, you cannot
unset one key without
unsetting all of the keys.
The key ID and key must be
the same on all neighboring
routers.
The valid range for
id_integer is 1 to 255.
key_str is an alphanumeric
string of up to 16 characters.
No default. All models.
authentication
must be set to
md5.
mtu Change the Maximum
Transmission Unit (MTU) size
included in database
description packets sent out
this interface. The valid range
for mtu_integer is 576 to
65535.
1500 All models.
mtu-ignore
{disable | enable} Use this command to control
the way OSPF behaves when
the MTU in the sent and
received database description
packets does not match.
When mtu-ignore is
enabled, OSPF will stop
detecting mismatched MTUs
and go ahead and form an
adjacency.
When mtu-ignore is
disabled, OSPF will detect
mismatched MTUs and not
form an adjacency.
mtu-ignore should only be
enabled if it is not possible to
reconfigure the MTUs so that
they match.
disable All models.
ospf-interface command keywords and variables (Continued)
Keywords and variables Description Default Availability