Config area, Config area command syntax pattern – Fortinet 100A User Manual
Page 167
Router
config router ospf
FortiGate-100A Administration Guide
01-28007-0068-20041203
167
get router ospf
This example shows how to display the OSPF configuration.
show router ospf
config area
Access the config area subcommand using the config router ospf
command. Use this command to set OSPF area related parameters.
Routers in an OSPF autonomous system (AS) or routing domain are organized into
logical groupings called areas. Areas are linked together by area border routers
(ABRs). There must be a backbone area that all areas can connect to. You can use a
virtual link to connect areas that do not have a physical connection to the backbone.
Routers within an OSPF area maintain link state databases for their own areas.
config area command syntax pattern
config area
edit
set
end
config area
edit
unset
end
config area
delete
end
config area
edit
get
end
config area
edit
show
end
The config area command has 3 subcommands.
Note: Any IP address is a valid area ID. An area ID of 0.0.0.0 indicates the backbone area.
Note: All area keywords are optional.