Fortinet 100A - Manual (Page 138)

138
01-28007-0068-20041203 Fortinet Inc.
Configuring routing for a virtual domain System virtual domain
4 Select OK.
5 Go to System > Network > Zone.
6 Select Create new.
See
“Zone” on page 58 . Any zones that you add are added to the current virtual
domain.
Configuring routing for a virtual domain
To configure routing for a virtual domain in NAT/Route mode
1 Go to System > Virtual domain > Virtual domains.
2 Select Change following the current virtual domain name above the table.
3 Choose the virtual domain for which to configure routing.
4 Select OK.
5 Go to Router.
6 Configure routing for the current virtual domain as required.
See
“Router” on page 141 . Network traffic entering this virtual domain is routed only
by the routing configuration for the current virtual domain.
To configure the routing table for a virtual domain in Transparent mode
1 Go to System > Virtual domain > Virtual domains.
2 Select Change following the current virtual domain name above the table.
3 Choose the virtual domain for which to configure routing.
4 Select OK.
5 Go to System > Network > Routing Table.
6 Configure the routing table for the current virtual domain as required.
See
“Routing table (Transparent Mode)” on page 62 . Network traffic entering this
virtual domain is routed only by the static routes added to the current virtual domain.
Configuring firewall policies for a virtual domain
To add firewall policies to a virtual domain
The following procedure applies to NAT/Route and Transparent mode.
1 Go to System > Virtual domain > Virtual domains.
2 Select Change following the current virtual domain name above the table.
3 Choose the virtual domain for which to configure firewall policies.
4 Select OK.
5 Go to Firewall > Policy.