HP TX1000 - Manual (Page 73)

Pen holder
Description Spare part number
Pen holder 441146-001
Pen eject assembly 441145-001
Before removing the pen holder, follow these steps:
1 . Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2 . Disconnect all external devices connected to the computer.
3 . Disconnect the power cord.
4 . Remove the battery (see Battery on page 36 ).
5 . Remove the following components:
a . Pen (see Pen on page 37 )
b . Hard drive (see Hard drive on page 38 )
c . Memory module compartment cover (see Memory module on page 43 )
d . Optical drive (see Optical drive on page 42 )
e . Keyboard (see Keyboard on page 47 )
f . Switch cover (see Switch cover on page 50 )
g . Display assembly (see Display assembly on page 52 )
h . Top cover (see Top cover on page 59 )
i . Power switch assembly (see Power switch assembly on page 63 )
j . System board (see System board on page 66 ).
Remove the pen holder:
1 . Remove the Phillips PM2.0×5.0 screw (1) that secures the pen eject assembly to the base enclosure.
2 . Remove the pen eject assembly (2).
3 . Remove the two Phillips PM2.0×5.0 screws (3) that secure the pen holder to the base enclosure.
68 Chapter 5 Removal and replacement procedures ENWW