HP TX1000 - Manual (Page 70)

Bluetooth module
Description Spare part number
Bluetooth module (includes Bluetooth module cable) 412766-002
Before removing the Bluetooth module, follow these steps:
1 . Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2 . Disconnect all external devices connected to the computer.
3 . Disconnect the power cord.
4 . Remove the battery (see Battery on page 36 ).
5 . Remove the following components:
a . Hard drive (see Hard drive on page 38 )
b . Optical drive (see Optical drive on page 42 )
c . Keyboard (see Keyboard on page 47 )
d . Switch cover (see Switch cover on page 50 )
e . Display assembly (see Display assembly on page 52 )
f . Top cover (see Top cover on page 59 ).
Remove the Bluetooth module:
1 . Disconnect the Bluetooth module cable (1) from the system board.
2 . Remove the Phillips PM2.0×3.0 screw (2) that secures the Bluetooth module to the system board.
3 . Remove the Bluetooth module (3).
Reverse this procedure to install the Bluetooth module.
ENWW Component replacement procedures 65