HP TX1000 - Manual (Page 62)

18 . Disconnect the fingerprint reader board cable (1) from the fingerprint reader board.
19 . If it is necessary to replace the fingerprint reader board, remove the Phillips PM2.0×4.0 screw (2)
that secures the fingerprint reader board and bracket to the display bezel.
20 . Remove the fingerprint reader board bracket (3).
21 . Lift the left side of the fingerprint reader board (4) and remove the board from the display bezel.
NOTE: The fingerprint reader board and bracket are available using spare part number
441121-001.
22 . If it is necessary to replace the display inverter, remove the Phillips PM2.0×4.0 screw (1) that secures
the inverter to the display enclosure.
23 . Disconnect the backlight cable (2) and the display panel cable (3) from the inverter.
24 . Remove the display inverter (4).
NOTE: The display inverter is available using spare part number 441119-001.
ENWW Component replacement procedures 57