HP 1055CMHP User Manual
Page 51
System Error Codes
2-17
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error:
0C0032 (Continuable)
Problem
Description:
Drop Detector not Calibrated for all Printheads.
Corrective Action:
Try the following:
n
Perform the Service Station Calibration
⇒
Page 5-11.
n
Replace the Drop Detector Assembly
⇒
Page 8-10.
n
If the Error Code continues, replace the Electronics Module
⇒
Page 8-25.
WARNING
Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error:
0C1000
Problem
Description:
Primer not Calibrated.
Corrective Action:
Try the following:
n
Perform the Service Station Calibration
⇒
Page 5-11.
n
Make sure that the Primer Arm is not damaged. If the Primer
Arm is damaged, replace the Service Station
⇒
Page 8-8.
n
Replace the Electronics Module
⇒
Page 8-25.
System Error:
0C1001
Problem
Description:
Primer Shutdown Error.
Corrective Action:
Try the following:
n
Check that the Primer Stepper-Motor Cable is NOT broken or
damaged and that the Primer arm moves freely from side to side.
n
Replace the Service Station
⇒
Page 8-8.
n
If the Error Code continues, replace the Electronics Module
⇒
Page 8-25.
WARNING
Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.