HP 1055CMHP - Manual (Page 230)

Removal and Installation
8-22
HP DesignJets 1050C and 1055CM Printers Service Manual
NOTE For the following steps, refer to Figure 20.
6. Remove the two T-10 screws (item 1) from the left roller gear (item
2) attached to the left side of the roller.
7. Remove the two T-20 screws (item 3) from the roller support (item
4) and remove the support.
8. Release the tension from the torsion spring (item 5) by removing the
arm of the spring off the spring hook (item 6).
9. Remove the two T-15 screws (item 7) from the pinch sensor bracket
(item 8) and remove the bracket with the sensor attached. Release
the sensor cable from retaining clips to remove completely.
10. Remove the spring hook (T-15) (item 6).
Figure 20: Miscellaneous Parts
3*
1*
2*
4*
5
6
7
7
8
C607420b
1*
3*
7
removing the Paper Entry Assembly or
*
These items do not need to be removed when
the Center Guide