HP 1055CMHP - Manual (Page 109)

Service Tests and Utilities
4-35 HP DesignJets 1050C and 1055CM Printers Service Manual
4. Printer Model Type
The purpose of this Service Utility is to set the correct Printer
Model.
NOTE The Printer Model Type only needs to be set when both the Tubes
System and the Electronics Module have been replaced at the
same time.
Set the Printer Model Type as follows:
1 In the Service Utilities submenu, scroll to "4. Printer Model Type"
and press Enter.
2 When the following message appears on the front panel, you must
select which Printer Model you would like to set. Select either the
HP DJ 1050C or the HP DJ 1055CM and press Enter.
3 The following message will appear asking you to confirm the
selection. Select ACCEPT if you want to set the Printer Model
(selected in the previous step), or select CANCEL if you want to
cancel the selection. Press Enter once the selection has been made.
Top
Enter
Back
↑
↓
Press Enter
Service Utilities
4. Printer Model Type
5. Overdrive Cleaning
1. Tubes Purge
2. Release Info
3. Set Asian PS Font Make Selection
PRINTER MODEL TYPE
Select the Printer’s
Model
HP DJ 1050C
HP DJ 1055CM
Top
Enter
Back
↑
↓
Press Enter
Make Selection
PRINTER MODEL TYPE
HP DJ 1050C
Model Selected
CANCEL
ACCEPT
Top
Enter
Back
↑
↓
Press Enter
Make Selection