HP 1055CMHP - Manual (Page 128)

Service Calibrations
5-12
HP DesignJets 1050C and 1055CM Printers Service Manual
3 If you selected to continue, then the following message appears on
the front panel if media is not loaded. You must load Media in to the
Printer to continue.
4 The Printer will start to print the calibration pattern and the
following messages will be displayed on the front panel:
5 Once the service station calibration is completed, the following
message will be displayed on the front panel:
6 To check if the Calibration was completed correctly, print the
Service Configuration Print (see Page 1-19) and check that the
calibrations are done and are within the stated limits.
perform this operation
Please, load paper to
and try again
Press ENTER to continue
Top
Enter
Back
↑
↓
Press Enter
ACCURACY
Calibrating
Please wait.
Performing service
position calibration.
Please wait.
Performing drop
detector calibration.
ACCURACY
Calibrating
Please wait.
Performing platen
distance calibration.
Please wait.
Performing primer
calibration.
Press ENTER to continue
Top
Enter
Back
↑
↓
Press Enter
Service station
calibration
finished.
Check that the Calibrations are done and within the limits