HandHeld Entertainment Document Reader 4800dr - Manual (Page 47)

4800dr Barcode Guide 5 - 3
Data Format Editor
Data Formatter
When Data Formatter is turned off, the barcode data is output to the host as read (including prefixes and suffixes). Choose one
of the following options. Default = Data Formatter On, but Not Required.
When Data Formatter is required, all input data must conform to an edited format or the document reader does not transmit the
input data to the host device.
Alternate Data Formats
Alternate formats allow you “single shot” capability to scan one barcode using a different data format than your primary format.
When data formats are programmed (see page 5-1 ), you must input whether you are programming the primary format, or an
alternate format numbered 1, 2, or 3.
An alternate format is initiated by scanning one of the 3 alternate format barcodes below. The document reader will scan the
next barcode, formatting the data with the selected alternate format, then revert immediately to the primary format.
Enter Data Format
* Default Data Format
Clear One Data Format
Save
Discard
Clear All Data Formats
Data Formatter Off
* Data Formatter On,
but Not Required
Data Format On, Format Required
Alternate Data Format 1
Alternate Data Format 2
Alternate Data Format 3