Intercharacter delay, User specified intercharacter delay, Interfunction delay – HandHeld Entertainment Document Reader 4800dr User Manual
Page 42
4 - 4
4800dr Barcode Guide
Intercharacter Delay
An intercharacter delay of up to 495 milliseconds (in 5 ms steps) may be placed between the transmission of each character of
scanned data. Scan the Intercharacter Delay barcode below, then scan the number of 5 millisecond steps (0-99), and the Save
inside the back cover of this manual.
To remove this delay, scan the Intercharacter Delay barcode, then set the number of steps to 0. Scan the Save barcode using
inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 495 milliseconds (in 5 ms steps) may be placed after the transmission of a particular character
of scanned data. Scan the Delay Length barcode below, then scan the number of 5 millisecond steps (0-99), and the Save
inside the back cover of this manual.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for the ASCII character that will trigger the delay
ASCII Conversion Chart (Code Page 1252)
To remove this delay, scan the Delay Length barcode, and set the number of steps to 0. Scan the Save barcode using the
inside the back cover of this manual.
Interfunction Delay
An interfunction delay of up to 495 milliseconds (in 5 ms steps) may be placed between the transmission of each segment of the
message string. Scan the Interfunction Delay barcode below, then scan the number of 5 millisecond steps (0-99), and the Save
inside the back cover of this manual.
To remove this delay, scan the Interfunction Delay barcode, then set the number of steps to 0. Scan the Save barcode using
inside the back cover of this manual.
1
2
3
4
5
Intercharacter Delay
Prefix
Scanned Data
Suffix
Intercharacter Delay
Delay Length
Character to Trigger Delay
Interfunction Delays
Prefix
Scanned Data
Suffix
1
2 3 4 5
STX
HT
CR
LF
Interfunction Delay