HandHeld Entertainment Document Reader 4800dr - Manual (Page 24)

3 - 2 4800dr Barcode Guide
Beeper Duration – Good Read
The beeper duration codes modify the length of the beep the document reader emits on a good read. Default = Normal.
LED – Good Read
The LED indicator can be programmed On or Off in response to a good read. Default = On.
LED – Indicator State
The LED indicator can be programmed to have an idle state of either Off or On, with a good read blink in the opposite state.
When programmed to LED Indicator Off, the LED indicator is Off in its idle state. It blinks On for a good read, then returns to
its idle Off state. When programmed to LED Indicator On, the LED indicator is On in its idle state. It blinks Off for a good read,
then returns to its idle On state. (LED Indicator On can also be used as a power on indicator.) Default = LED Indicator Off.
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of beeps will be applied to the beeper
and LED in response to a good read. For example, if you program this option to have five beeps, there will be five beeps and five
LED flashes in response to a good read. The beeps and LED flashes are in sync with one another. To change the number of
beeps, scan the barcode below and then scan a digit (1-9) barcode and the Save barcode on the Programming Chart inside the
back cover of this manual. Default = One.
* Normal Beep
Short Beep
* On
Off
* LED Indicator Off
LED Indicator On
Number of Pulses