HandHeld Entertainment Document Reader 4800dr - Manual (Page 33)

4800dr Barcode Guide 3 - 11
High Priority Symbology
To specify the high priority symbology, scan the High Priority Symbology barcode below. On the Symbology Chart on page A-
1, find the symbology you want to set as high priority. Locate the Hex value for that symbology and scan the 2 digit hex value
from the Programming Chart (inside back cover). Scan Save to save your selection. Default = None
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology barcode below. On the Symbology Chart on page A-1,
find the symbology you want to set as low priority. Locate the Hex value for that symbology and scan the 2 digit hex value from
the Programming Chart (inside back cover).
If you want to set additional low priority symbologies, scan FF, then scan the 2 digit hex value from the Programming Chart for
the next symbology. You can program up to 5 low priority symbologies. Scan Save to save your selection. Default = None
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low priority symbologies, you must set the time-out
period. This is the period of time the document reader will search for a high priority barcode after a low priority barcode has been
encountered. Scan the barcode below, then set the delay (from 100-3,000 milliseconds) by scanning digits from the inside back
cover, then scanning Save. Default = 500 ms.
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default values.
Output Sequence Overview
Require Output Sequence
When turned off, the barcode data will be output to the host as the Document Reader decodes it. When turned on, all output
data must conform to an edited sequence or the document reader will not transmit the output data to the host device.
Note: This selection is unavailable when Multiple Symbols (page 3-14) is enabled.
Output Sequence Editor
This programming selection allows you to program the document reader to output data (when scanning more than one symbol)
in whatever order your application requires, regardless of the order in which the barcodes are scanned. Reading the Default
Sequence
symbol programs the document reader to the Universal values, shown below. These are the defaults. Be certain
you want to delete or clear all formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you’ll need to know the code I.D., code length, and character match(es) your
application requires. Use the Alphanumeric symbols (inside back cover) to read these options.
You must hold the trigger while reading each barcode in the sequence.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see Require Output Sequence , page 3-13).
High Priority Symbology
Low Priority Symbology
Preferred Symbology Time-out
Preferred Symbology Default