HandHeld Entertainment Document Reader 4800dr - Manual (Page 36)

3 - 14 4800dr Barcode Guide
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple symbols with a single pull of the Document Reader’s
trigger. If you press and hold the trigger, aiming the Document Reader at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The document reader attempts to find and decode new symbols as long as the trigger is
pulled. When this programming selection is turned Off, the Document Reader will only read the symbol closest to the aiming
beam.
No Read
With No Read turned On, the Document Reader notifies you if a code cannot be read. The document reader outputs an “NR”
appears when a code cannot be read. If No Read is turned Off, the “NR” will not appear.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” you can edit the output message using the Data
Formatter (page 5-3). The hex code for the No Read symbol is 9C.
Print Weight
Print Weight is used to adjust the way the document reader reads Matrix symbols. If a document reader will be seeing
consistently heavily printed matrix symbols, then a print weight of 6 may improve the reading performance. For consistently light
printing, a print weight of 2 may help. After scanning the Set Print Weight barcode, set the print weight (from 1-7) by scanning
digits from the inside back cover, then scanning Save. Default = 4.
On
* Off
On
* Off
Set Print Weight
* Default