HandHeld Entertainment Document Reader 4800dr - Manual (Page 25)

4800dr Barcode Guide 3 - 3
Good Read Delay
This sets the minimum amount of time before the document reader can read another barcode. Default = No Delay.
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode below, then set the delay (from 0-30,000
milliseconds) by scanning digits from the inside back cover, then scanning Save.
Trigger Modes
Manual/Serial Trigger
You can activate the document reader either by pressing the trigger, or using a serial trigger command (see Trigger Commands
on page 10-3). When in manual trigger mode, the document reader scans until a barcode is read, or until the trigger is released.
When in serial mode, the document reader scans until a barcode has been read or until the deactivate command is sent. In serial
mode, the document reader can also be set to turn itself off after a specified time has elapsed (see Read Time-Out , which
follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the document reader’s trigger when using serial commands to trigger the
document reader, or if the document reader is in manual trigger mode. Once the document reader has timed out, you can
activate the document reader either by pressing the trigger or using a serial trigger command. After scanning the Read Time-
Out
barcode, set the time-out duration (from 0-300,000 milliseconds) by scanning digits from the inside back cover, then
scanning Save. Default = 30,000.
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay
* Manual/Serial Trigger
Read Time-Out