HP 5/xx Series 4 - Manual (Page 70)

4 The HP Setup Program
Using the HP Setup Program
58 English
Memory and Cache
Memory caching Both Controls internal (L1) and external cache (L2) memory
caching.
Memory hole Disabled Sets a 1MB memory hole between 15 and 16MB if
needed. You need at least 16 MB for this option to be
available.
Shadow/Cache ISA Option
ROMs Enabled Enables shadowing and caching for ISA “Non-PnP” Option
ROMs for region X-Y, in order to improve performance.
Note that some Option ROMs cannot be shadowed.
Hard Disk Drives
Hard disk drive 0 (xxxx MB) 540 MB Configure IDE drive 0. It is not recommended to connect a
CD-ROM on a channel which already has an IDE hard disk
drive. Sub-menu items for each of these fields are given
below “On-board Bus IDE adapters” in this table.
Hard disk drive 1 (xxxx MB) xxx MB
Hard disk drive 2 (xxxx MB) xxx MB
Hard disk drive 3 (xxxx MB) xxx MB
Translation method Extended Select “Standard” only if you are running a UNIX
Operating System.
On-board Bus IDE adapters Both Enable or disable the on-board IDE adapters.
“Primary” enables only the HDD data cable (marked
“HDD” next to the system board attachment).
“Both” enables the HDD data cable and the CD-ROM data
cable (marked “CD-ROM” next to the system board
attachment).
Autotype fixed disk Automatically attempts to detect and identify the IDE
drive when you press the Enter key.
Type User 540 MB Select “Auto” for automatic hard disk drive detection. (To
initiate automatic hard disk detection, press the Enter key
at the “Autotype fixed disk” item). “User” allows you to
edit all the detected parameters. Select “CD” if drive is an
IDE CD-ROM, and “None” if there is no drive.
Cylinders 944 Sets the number of hard disk drive cylinders.
Heads 14 Sets the number of hard disk drive heads.
Sectors/Track 40 Sets the number of hard disk drive sectors per track.
Multi-sector transfers 8 sectors Determines the number of sectors per block for multiple
sector transfers.
LBA mode control Enabled Enable or disable Logical Block Addressing mode in place
of Cylinder Heads Sectors.
32 bit I/O Enabled Enable or disable 32 bit data transfer.
Transfer mode PI0 mode 3 Selects the hard disk drive transfer mode and data
transfer rate.
Setup Item Default Action
uno.bk : uno4_stu.fb4 Page 58 Monday, July 21, 1997 12:46 PM