HP 5/xx Series 4 - Manual (Page 49)

English 37
3 How to Install Accessories In Your PC
Installing Mass Storage Devices
5 Connect the data and power cables to the rear of the device installed
in the middle shelf. The connectors are shaped to go in one way
only. If you are installing an IDE CD-ROM drive, connect the drive
to the CD-ROM data cable. This data cable should be connected to
the connector marked “CD-ROM” on the system board. If you are not
sure which connector to use, refer to “Connecting an IDE Device to
a Data Cable” on page 39.
6 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
WARNING Do not open the CD-ROM drive enclosure as there is a danger of
electric shock, and the laser beam light could harm your eyes. Service
should be carried out by qualified personnel.
To avoid discomfort from unexpected noise, always turn the volume
down before connecting headphones or speakers.
Listening to loud sounds for prolonged periods may permanently
damage your hearing.
Before putting on headphones, place them round your neck and turn
the volume down. When you put on the headphones, slowly increase
the volume until you find a comfortable listening level and leave the
volume control in that position.
Data cable Power cable
uno.bk : uno3_ins.fb4 Page 37 Monday, July 21, 1997 12:46 PM