HP 5/xx Series 4 - Manual (Page 69)

English 57
4 The HP Setup Program
Using the HP Setup Program
Configuration
Integrated Peripherals
Parallel port 378h IRQ7 Enables/disables the parallel port at the specified address.
“Disabled” frees resources used by the port.
Parallel port Mode Centronics TM Sets the operating mode of the parallel port.
Serial port A 3F8h IRQ4 Enables/disables the on-board serial port A. “Disabled”
frees resources used by the port.
Do not select 2E8h if you are running Windows 95.
Serial port B 2F8h IRQ3 Enables/disables the on-board serial port B. “Disabled”
frees resources used by the port.
Do not select 2E8h if you are running Windows 95.
Flexible disk controller Enabled Enables or disables the on-board flexible disk controller.
Flexible disk drive 1 1.44MB,3 1/2” Selects the flexible disk drive type.
Flexible disk drive 2 Not Installed Selects the flexible disk drive type.
A & B flexible disk swap Disabled Enable this option only if you need to boot on flexible disk
B. Then flexible disks A and B will be swapped.
Video
Video system EGA/VGA Select video display type.
Video BIOS shadowing Enabled Enables / disables video BIOS shadowing (for AT external
boards only) Enabling the BIOS shadowing improves
performance.
Video Plug & Play display Enabled Sets the best ergonomic refresh rates supported by your
DDC compliant display. Switch on the display before the
PC to enable this feature. If the display does not support
DDC, the BIOS might automatically disable the option.
640x480 mode 60Hz Set your preferred refresh rate for each graphic mode. All
refresh rates may not be available for certain color
depths. The video BIOS will automatically choose the
best fit should this be the case. The higher the refresh
rate, the better the ergonomic performance. The lower
the refresh rate, the better the video performance. Your
display must be able to support the refresh rates (vertical
frequencies) you set.
800x600 mode 60Hz
1024x768 mode 60Hz
1280x1024 mode i45Hz
Setup Item Default Action
uno.bk : uno4_stu.fb4 Page 57 Monday, July 21, 1997 12:46 PM