Energizer 715 - Manual (Page 156)

134 Chapter: 9
I cannot get to the User Settings menu
If you do not hold down the button while pressing ACT when you
have User Settings highlighted, you will see the following screen:
1 Go to the Utilities screen and highlight User Settings. Then, hold
down the button and press ACT.
2 See “User settings” on page 123 for information about the menu
options.
Alert conditions
Your pump has a sophisticated network of safety checks and systems. If it
detects an unusual condition that requires your immediate attention, it will
beep or vibrate periodically to alert you. The pump will go into Special
mode (an open circle will display), and the backlight will illuminate. The
alert message will also appear on the screen.
➠ Why are alerts important?
Your pump monitors activities and will alert you if a Special mode is active. Some alerts are a normal
part of pump therapy, such as an active temporary basal. There are alerts that indicate a condition
that is outside normal pump activity. For example, your pump notifies you with an alert when you
need to replace the reservoir (LOW RESERVOIR) or replace your pump battery (LOW BATTERY).
What to do
When your pump beeps or vibrates notifying you that an alert condition exists:
1 Read and follow the instructions on the screen. Press ESC , ACT to silence an alert.
2 Check the STATUS screen to determine what caused the alert.
3 If the condition is due to a low battery, replace the battery.
4 If the condition is due to a low reservoir, monitor the reservoir volume frequently and change the
reservoir when appropriate. Make sure you have a new reservoir, infusion set and vial of insulin with
you.
➠ Dual Wave or Square Wave bolus
delivery
➠ Pattern A or B is active
➠ Temp basal delivery
➠ Block feature is on
➠ Low reservoir
➠ Low battery
This feature is not
normally accessible. To
access, consult your
User Guide.