Energizer 715 - Manual (Page 131)

Utilities 109
Chapter: 8
Utilities
Alarm review
You can review alarms in the ALARM HISTORY screen. This screen shows up to 36 past alarms and/or
errors. You can also review the details for each alarm when you are in the ALARM HISTORY screen.
1 Go to the ALARM HISTORY screen
Main > Utilities > Alarm > Alarm History
2 Scroll through your past alarms.
3 If you want to review the details for an alarm, continue to
“Alarm details” below. Exit the menus if you are done.
Alarm details
4 In the ALARM HISTORY screen, select the alarm you want to
review and press
ACT . The details for that alarm will appear on
the screen.
5 Press ESC to return to the ALARM HISTORY screen. Select
another alarm to review, or exit the menus if you are done.
Setting your alert type
You can select the type of alert your pump uses (for alarms, special conditions and programming).
You can select a vibrate (silent) alert, or an audible beep alert. There are three beep types: long,
medium and short tones. The factory setting for this feature is beep-medium.
The vibrate alert type is disabled if you use the block feature, and vibrate must be set again once
block is turned off. If your alert type is set to vibrate and you get a LOW BATTERY alert, your pump will
use the beep alert type instead to conserve battery power.
NOTE -
Vibrate uses more battery power than the beep alert type and may shorten battery life.
11OCT 10:35P LoRes
ALARM HISTORY
08OCT 04:08P ChkSet
05OCT 11:35A LoBat
LOW RESERVOIR
24-hours remaining
0.25 units remaining >
11OCT 10:35P