Nikon Zfc Mirrorless Camera with 28mm Lens - Manual (Page 613)

Bluetooth and Wi-Fi (wireless LAN)
613
no proof, however, that these low power wireless devices are absolutely
safe. Low power Wireless devices emit low levels of radio frequency
energy (RF) in the microwave range while being used. Whereas high
levels of RF can produce health effects (by heating tissue), exposure of
low-level RF that does not produce heating effects causes no known
adverse health effects. Many studies of low-level RF exposures have not
found any biological effects. Some studies have suggested that some
biological effects might occur, but such findings have not been
confirmed by additional research. This product has been tested and
found to comply with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines and RSS-102 of the ISED radio frequency (RF)
Exposure rules. Please refer to the SAR test report that was uploaded to
FCC website.
Compliance with RSS-247 Issue 2 §6.4
Data transmission is always initiated by software, which is the passed
down through the MAC, through the digital and analog baseband, and
finally to the RF chip. Several special packets are initiated by the MAC.
These are the only ways the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of the packet. Therefore,
the transmitter will be on only while one of the aforementioned packets
is being transmitted. In other words, this device automatically
discontinue transmission in case of either absence of information to
transmit or operational failure.
Notice for customers in Canada ●
For indoor use only (5150-5350MHz).