Brother HL-L3230CDW Wireless Compact Printer User Manual
Page 219
Error Message
Cause
Action
Replace Drum
It is time to replace the drum unit.
Replace the drum unit for the color indicated
on the LCD.
See
Related Information
:
Replace the Drum
Unit.
If this message is displayed even
after replacing the drum unit with
new one, the drum unit counter
was not reset.
Reset the drum unit counter.
See
Related Information
:
Replace the Drum
Unit.
Replace Toner
The toner cartridge is at the end of
its life. The machine stops all print
operations.
Replace the toner cartridge for the color
indicated on the LCD.
See
Related Information
:
Replace the Toner
Cartridge.
Replace WT Box
It is time to replace the waste
toner box.
Replace the waste toner box with a new one.
See
Related Information
:
Replace the Waste
Toner Box.
Self-Diagnostic
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
Press and hold
to turn off the machine,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
The fuser unit is too hot.
Short paper
The length of the paper in the tray
is too short for the machine to
deliver it to the Face down output
tray.
Open the back cover (Face up output tray) to
let the printed page exit onto the Face up
output tray. Remove the printed pages, and
then press
Go
.
Size Error
The paper size defined in the
printer driver is not supported by
the defined tray.
Choose a paper size supported by the defined
tray.
Size Error DX
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
Press
Cancel
(if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper sizes available for automatic 2-sided
printing are Letter, Legal, Mexico Legal, India
Legal and Folio.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
Size Mismatch
The paper in the tray is not the
correct size.
Load the correct size of paper in the tray and
set the size of paper for the tray. Press
Go
.
Toner Error
One or more toner cartridges are
not installed or not installed
correctly.
Pull out the drum units. Remove all the toner
cartridges, and then put them back into the
drum units.
Toner Low: BK
Toner Low: C
Toner Low: M
Toner Low: Y
(BK=Black, C=Cyan,
M=Magenta, Y=Yellow.)
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
Order a new toner cartridge before the LCD
displays
Replace Toner
.
WT Box End Soon
The waste toner box is almost full. Order a new waste toner box before the LCD
displays
Replace WT Box
.
214