AG Neovo PD-55Q 55" 4K Commercial Display - Manual (Page 79)

74
ADJUSTING THE LCD DISPLAY
Item Function Operation Range
OSD
transparency
Adjust OSD transparency.
• Off: Transparency is off.
• 5-100: Transparency level is
5-100.
Press the / button on the
control panel or the /
button
on the remote control to adjust the
value.
Off
5 to 100
Standby
Select the standby mode when the
display cannot detect any input
source signal.
• Mode 1 [TCP off, WOL on, auto
off]
 DC off -> Power off.
LED: Red.
 Standby -> Power off. LED:
Red
• Mode 2 [TCP off, WOL on, auto
on/off]
 DC off -> Power off.
LED: Red.
 Standby -> Power Saving.
LED: Orange. Can be wake
up.
• Mode 3 [TCP on, WOL off, auto
on/off]
 DC off -> Back light off.
LED: Red.
 Standby -> Back light off.
LED: Orange. Can be wake
up.
• Mode 4 [TCP on, WOL off, no
auto on/off]
 DC off -> Back light off.
LED: Red

Standby -> Will not enter
standby mode. Only show “no
signal”.
Note: For RS232 and LAN control
configuration, this setting must
be set to Mode 3 or Mode 4.
1 Press the / button on the
control panel or the / button on
the remote control to select the
setting.
2 Press the button on the
control panel or the button
on the remote control to set the
value.
Mode 1
Mode 2
Mode 3
Mode 4