AG Neovo PD-55Q 55" 4K Commercial Display - Manual (Page 24)

20
PRODUCT DESCRIPTION
1.7.2 ID Remote Control
You can set the remote control ID when you
want to use this remote control on one of several
different displays.
To set the remote control ID:
1 Press the ID button. The red LED blinks
twice.
2 Press the ID SET button for more than
1 second to enter the ID mode. The red
LED lights up.
Press the
ID SET button again will exit
the ID mode. The red LED lights off.
3 Press the digit numbers [0] ~ [9] to
select the display you want to control.
For example:
• Display ID #1: press [0], [1]
• Display ID #11: press [1], [1]
The numbers available are from [01] ~
[255].
• Not pressing any button within 10
seconds will exit the ID mode.
• If an error pressing of buttons other
than the digits occured, wait 1
second after the red LED lights off
and then lights up again, then press
the correct digits again.
4 Press the ENTER button to confirm.
The red LED blinks twice and then
lights off.
Note:
♦ Press the NORMAL button. The green LED
blinks twice, indicating the remote control
returns to normal operation.
♦ It is necessary to set up the Monitor ID for
each display before selecting its ID number.