AG Neovo PD-55Q 55" 4K Commercial Display - Manual (Page 63)

58
ADJUSTING THE LCD DISPLAY
Item Function Operation Range
Panel saving
Choose to enable the panel saving
functions and thus reduce the risk
of “image persistence” or “ghost-
imaging”.
1 Press the / button on the
control panel or the / button on
the remote control to select the
setting.
2 Press the button on the
control panel or the button
on the remote control to set the
value.
Brightness
ANTI-BURN-
IN TM
Brightness: Set to On and the
image brightness will be reduced
to an appropriate level. The
Brightness setting in the Picture
menu will be unavailable when
selected.
Off
On
ANTI-BURN-IN TM : Select the time
interval for the display to slightly
expand the image size and shift the
position of pixels in four directions
(up, down, left, or right).
Note: Activating ANTI-BURN-IN TM
will disable H Position, V Position
and Zoom Mode in the Screen
Menu.
Press the / button on the
control panel or the /
button
on the remote control to adjust the
value.
Off
Auto
10 to 900
Seconds
RS232-Routing Select the network control port.
1 Press the / button on the
control panel or the / button on
the remote control to select the
setting.
2 Press the button on the
control panel or the button
on the remote control to set the
value.
RS232
LAN -> RS232
Boot on source
Set the default source at boot up.
Last Input: Input source is the same
as at last boot.
1 Press the / button on the
control panel or the / button
on the remote control to select
Last Input option.
2 Press the button on the
control panel or the button
on the remote control to set the
value.
CANCEL
SAVE