AG Neovo PD-55Q 55" 4K Commercial Display - Manual (Page 78)

73
ADJUSTING THE LCD DISPLAY
Item Function Operation Range
Auto signal
detection
Choose to let the display detect and
display from available video inputs
automatically.
This function takes place only when
there is no signal connected at the
input port you designate for auto-
detection.
Note:
• If the setting is set to All , the
system will automatically search
the available input signal in the
following order: HDMI1, HDMI2,
HDMI3, DVI-I, DisplayPort,
VGA, SDM, or USB.
• If the setting is set to
Failover , you can configure
the input source priority list
(Failover1~Failover8) in case
of multiple sources. The default
input source is HDMI1.
1 Press the / button on the
control panel or the / button on
the remote control to select the
setting.
2 Press the button on the control
panel or the button on the
remote control to set the value.
Off
All
Failover
Language Set the OSD language.
1 Press the button on the
control panel or the button
on the remote control to select
the value.
2 Press the / button on the
control panel or the / button on
the remote control to select the
setting.
3 Press the button on the
control panel or the button
on the remote control to set the
setting.
4 Press the button on the
control panel or the button
on the remote control. Then
press the / button on the
control panel or the / button
on the remote control to select
CANCEL or OK .
English
Español
Français
Italiano
Latviešu
Lietuvių
Nederlands
Norsk bokmål
Polski
Português
Suomi
Svenska
Türkçe
Pyccкий
ﺔﻴﺑﺮﻌﻟا
简体中文
繁體中文
日本語
Čeština
Dansk
Deutsch
Eesti
CANCEL
OK