Epson WorkForce Pro WF-C8690 A3 Color MFP with PCL/PostScript - Manual (Page 447)

447
• Do not use aerosol products that contain flammable gases inside or around the product. Doing so may
cause fire.
• Do not press too hard on the document table when placing originals.
• Do not open the scanner section while the product is copying, printing, scanning, or performing any
other functions.
• Be careful not to trap your fingers when closing the document cover or scanner.
• Except as specifically explained in your documentation, do not attempt to service or disassemble the
product yourself.
• Unplug the product and refer servicing to qualified service personnel under the following conditions: if
the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped
or the case damaged; if the product does not operate normally or exhibits a distinct change in
performance. Adjust only those controls that are covered by the operating instructions.
• Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and may
prevent the product from printing.
• Before transporting the product, make sure that the print head is in the home (far right) position and
the ink cartridges are in place.
• When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside down;
otherwise ink may leak.
• Do not attempt to move the product by yourself.
Parent topic: Important Safety Instructions
Ink Cartridge Safety Instructions
• Keep ink cartridges out of the reach of children and do not drink the ink.
• Be careful when you handle used ink cartridges; there may be ink remaining around the ink supply
port. If ink gets on your skin, wash it off with soap and water. If it gets in your eyes, flush them
immediately with water. If you experience discomfort or vision problems after flushing your eyes, see a
doctor immediately. If ink gets in your mouth, see a doctor immediately.
• Do not put your hand inside the product or touch any cartridges during printing.
• Install a new ink cartridge immediately after removing an expended one. Leaving cartridges
uninstalled can dry out the print head and may prevent the product from printing.
• Do not remove or tear the label on the cartridge; this can cause leakage.
• Do not remove the transparent seal from the bottom of the cartridge. This may cause the cartridge to
become unusable.