Roland V-160HD SDI/HDMI Streaming Video Switcher - Manual (Page 68)

68
Other Functions
Using a Footswitch
You can use a footswitch connected to the CTL/EXP 1 and 2 jacks to control the V-160HD with your foot. You can assign various functions to the
footswitch.
1 . [MENU] button
Ó
“CTL/EXP”
Ó
“CTL/EXP 1” or “CTL/EXP 2”
Ó
select “CTL/EXP TYPE,” and press the [VALUE] knob.
2 . Set the connected device to “CTL A & CTL B” (the footswitch)
using the [VALUE] knob, and press the [VALUE] knob.
3 . Use the [VALUE] knob to select CTL A or CTL B “CATEGORY”
and “VALUE,” and press the [VALUE] knob.
4 . Use the [VALUE] knob to select the function that you want
to assign to CTL A or CTL B of the footswitch, and press
the [VALUE] knob.
Á CATEGORY
Value Explanation
N/A No function is assigned.
PGM CH SELECT Switches the PGM/A cross-point buttons.
PST CH SELECT Switches the PST/B cross-point buttons.
AUX CH SELECT Switches the video sent to the AUX bus.
INPUT 1–10 ASSIGN Changes the video assigned to INPUT 1–10.
STILL OUTPUT
Pauses the normal output, and previews or
final outputs a cut of the still image.
PinP & KEY 1–4 SOURCE Switches the video source of the inset screen.
DSK 1, 2 SOURCE Switches the DSK video source.
SW CONTROL
This works the same as when you press the
button selected in “VALUE.”
TAKE
Switches the video between PGM/A bus
and PST/B bus.
AUDIO INPUT MUTE
Turns the mute function on/off for the input
audio.
AUDIO OUTPUT MUTE
Turns the mute function on/off for the
output audio.
AUDIO INPUT SOLO
Turns the solo function on/off for the input
audio.
VOICE CHANGER SW Turns the voice changer on/off.
REVERB (MOMENTARY)
Reverb turns on only while you press the
footswitch.
REVERB (ALTERNATE) Turns reverb on/off.
OUTPUT FADE
The final output video fades out to a black
screen.
LOAD MEMORY Recalls a preset memory.
INPUT SCAN
Each time you press the footswitch, the
INPUT 1–10 video changes in order.
MEMORY SCAN
Each time you press the footswitch, preset
memories 1–30 are recalled in order.
MACRO EXECUTE
Executes a macro (a series of recorded
operations).
SEQUENCER
When the sequencer function is on, this
works the same as when you press the
button selected in “VALUE.”
GPO (ONE SHOT) Outputs a control signal for 0.5 seconds.
GPO (ALTERNATE)
The control signal output is switched on/off
with each press of the footswitch.
Á VALUE
Configures the detailed settings related to “CATEGORY.”
5 . Press the [MENU] button to close the menu.
MEMO
¹ See “Connecting a Footswitch” (p. 9) for how to connect a
footswitch to this unit.
¹ If a single-pedal type footswitch such as the BOSS FS-5U is
connected using a phone cable (mono), the function assigned
by “CTL B” is enabled.