Roland V-160HD SDI/HDMI Streaming Video Switcher - Manual (Page 23)

23
Video Operations
Capturing a Still Image from Input/Output Video
Here’s how to capture a still image from the input/output video.
1 . Press the [CAPTURE IMAGE] button to turn on (lit).
CAPTURE IMAGE screen appears, and the cross-point [1]–[8]
buttons blink yellow.
2 . Press a PGM/A or PST/B cross-point [1]–[8] button to select
a save destination memory (STILL 1–16) for the captured
still image.
Á Button assignments
PGM/A cross-point [1]–[8] STILL 1–8
PST/B cross-point [1]–[8] STILL 9–16
* If you decide to cancel, press the [EXIT] button.
3 . Press a button that is blinking red to select the input/
output video from which you want to capture.
Á Button assignments
PGM/A cross-point [1]–[8] SDI IN 1–8
PST/B cross-point [1]–[8] HDMI IN 1–8
[CUT] Final output
[AUTO] Preview output
PGM/A cross-point [10] SUB PROGRAM bus
The capture is executed. When the operation is finished, the
message “COMPLETE” appears.
4 . Press the [CAPTURE IMAGE] button to exit the operation.
MEMO
¹ You can set the method of saving still images to “temporarily
save.” When you turn off the power, the captured still image is
deleted.
From the [MENU] button
Ó
“STILL IMAGE,” set “SAVE TO
INTERNAL STORAGE” to “DISABLE,” and then capture the image.
¹ Depending on the format of the input video, completion of
still-image capture might take some time.
¹ If you capture when HDCP (p. 15) is on, the still image that is
created is handled in the same way as HDCP-protected video.
It cannot be used if HDCP is off.
Deleting a Still Image
Here’s how to delete the still image that’s saved in the unit.
1 . [MENU] button
Ó
“STILL IMAGE”
Ó
select “DELETE STILL
IMAGE,” and press the [VALUE] knob.
2 . Use the [VALUE] knob to select the still image (ALL, STILL
1–16) you want to delete, and press the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
3 . Use the [VALUE] knob to select “YES,” and press the
[VALUE] knob.
The still image is deleted. When the operation is finished, the
message “COMPLETE” appears.
4 . Press the [MENU] button to close the menu.