Roland V-160HD SDI/HDMI Streaming Video Switcher - Manual (Page 13)

13
Video Input/Output Settings
Assigning Video Sources
Here’s how to assign the video sources (input video and still images)
to the cross-point [1]–[10] buttons.
Using the buttons
1 . Press a cross-point button while holding down the [INPUT
ASSIGN] button.
The video source changes in the following order each time you
press the button.
[INPUT ASSIGN] + PGM/A cross-point buttons
STILL 16
У
1
У
SDI 8
У
1
У
HDMI 8
Ó
1
[INPUT ASSIGN] + PST/B cross-point buttons
HDMI 1
У
8
У
SDI 1
У
8
У
STILL 1
Ó
16
Using the menus
1 . [MENU] button
Ó
“VIDEO ASSIGN”
Ó
select “INPUT 1”–
“INPUT 10,” and press the [VALUE] knob.
2 . Use the [VALUE] knob to select the video source, and
press the [VALUE] knob.
3 . Press the [MENU] button to close the menu.
MEMO
You can import still images by using the following methods.
Ø
“Loading a Still Image from a USB Flash Drive” (p. 22)
Ø
“Capturing a Still Image from Input/Output Video” (p. 23)
Adjusting Output Video
Here’s how to adjust the output image appropriately for the device
that’s receiving the V-160HD’s output.
1 . [MENU] button
Ó
“VIDEO OUTPUT”
Ó
select “HDMI OUT
1–3” or “SDI OUT 1–3,” and press the [VALUE] knob.
2 . Use the [VALUE] knob to select a menu item shown below,
and press the [VALUE] knob.
HDMI OUT 1–3
Value Explanation
OUTPUT STATUS Shows the format and an HDCP signal presence.
COLOR SPACE Specifies the color space.
DVI-D/HDMI SIGNAL Specifies the type of output signal.
BRIGHTNESS Adjusts the brightness.
CONTRAST Adjusts the contrast.
SATURATION Adjusts the saturation.
RED Adjusts the red level.
GREEN Adjusts the green level.
BLUE Adjusts the blue level.
SDI OUT 1–3
Value Explanation
OUTPUT STATUS Shows the format.
3G-SDI MAPPING
Specifies the mapping structure of the 3G-SDI
output.
BRIGHTNESS Adjusts the brightness.
CONTRAST Adjusts the contrast.
SATURATION Adjusts the saturation.
3 . Use the [VALUE] knob to edit the value of the setting, and
press the [VALUE] knob.
4 . Press the [MENU] button to close the menu.
MEMO
You can output a test pattern, useful for adjusting the image
quality of a display.
Use the [MENU] button
Ó
“SYSTEM”
Ó
“TEST PATTERN” to specify
the test pattern.