ProSoft Technology MVI69-GEC - Manual (Page 78)

Contents MVI69-GEC ♦ CompactLogix or MicroLogix Platform
User Manual
Page 78 of 86 ProSoft Technology, Inc.
February 18, 2014
Parameter Block
Offset
Start Description
Rev 5 Revision level as ASCII string
OP 7 Operating system level as ASCII string
Run 9 Run number as ASCII string
BlkErrs.Read 11 Number of blocks transferred from module to processor
BlkErrs.Write 12 Number of blocks transferred from processor to module
BlkErrs.Parse 13 Number of blocks parsed by module
BlkErrs.Err 14 Number of block errors in module
Server[3].Enabled 15 This flag defines if the server is utilized. A value of 0
indicates the server is not used. Any other value indicates
the server is used.
Server[3].State 16 This flag defines the current state of the server.
Server[3].IP 17 This double-word value contains the IP address of the client
connected to the server.
Server[3].Port 19 This word value contains the port address for the client
connected to the server.
Server[3].Open 20 This status value contains the total number of times the
server performed an open operation.
Server[3].Established 21 This status value contains the total number of times a
connection was established on the socket.
Server[3].Closed 22 This status value contains the total number of times a close
operation was performed on the socket.
Server[3].RxCount 23 This status value contains the total number of messages
received by the server.
Server[3].RxOverflow 24 This status value contains the total number of messages
received that exceed the specified buffer size for the server.
Server[3].TxCount 25 This status value contains the total number of messages
transmitted by the server.
Server[3].TxOverflow 26 This status value contains the total number of transmit
messages that exceeded the specified maximum buffer size
for the server.
Server[3].Timeout 27 This status value contains the total number of times a
connection timeout occurred on the socket.
Server[3].CfgErrWord 28 This bit mapped word defines the configuration errors for the
server.
Server[4].Enabled 29 This flag defines if the server is utilized. A value of 0
indicates the server is not used. Any other value indicates
the server is used.
Server[4].State 30 This flag defines the current state of the server.
Server[4].IP 31 This double-word value contains the IP address of the client
connected to the server.
Server[4].Port 33 This word value contains the port address for the client
connected to the server.
Server[4].Open 34 This status value contains the total number of times the
server performed an open operation.