PLANET CS-2000 - Manual (Page 47)

CS-2000 UTM Content Security Gateway User’s Manual
- 41 -
Enable SNMP Trap Alert Notification
Step1. In Configure Æ SNMP , select Enable SNMP Trap Alert Notification and enter the following
setting:
„
SNMP Trap Recipient Address: enter SNMP trap recipient IP.
„ SNMP Trap Port: Enter the port number. (Default value: 162).
„ Click OK.
„ Complete the SNMP Trap setting. The MIS engineer can use the SNMP Trap software
and receive the alarm notification from the CS-2000 appliance.（it will send the
notification about connection / disconnection and the attacks information to the SNMP
Trap recipient address
.
SNMP Trap setting WebUI
The MIS engineer can click to test if SNMP Trap can work normally.