PLANET IGS-10020HPT - Manual (Page 544)

User’s Manual of IGS-10020PT / IGS-10020HPT
544
MEP Loop Back configuration
'set|clear' is set or clear of DEI of transmitted LBM frame
'prio' is the priority (PCP) of transmitted LBM frame
'uni|multi' is selecting uni-cast or multi-cast transmission of LBM frame
'mac_addr' is the unicast MAC of target MEP/MIP
'mep' is the peer MEP-ID of target MEP - only used if 'mac_addr is 'all zero'
'tosend' is the number of LBM to send
'size' is the size of the LBM data field
'gap' is the gap between LBM.
Syntax:
MEP lb config [] [set|clear] [] [uni|multi] [] [] [] [] [] [enable|disable]
Parameters:
: Instance number
set|clear : OAM DEI set/clear
: OAM PDU priority
uni|multi : Destination address is unicast or multicast
: MAC address ('xx-xx-xx-xx-xx-xx' or 'xx.xx.xx.xx.xx.xx' or 'xxxxxxxxxxxx', x is a hexadecimal digit)
: This MEP id (0-0x1FFF)
: Number of LBM to send
: Size of LBM data field in bytes (max 1400)
: Gap between LBM to send in 10ms. (max 100 - '0' is as fast as possible)
enable|disable: enable/disable
MEP Delay Measurement Configuration
Description:
MEP Delay Measurement configuration
'prio' is the priority (PCP) of transmitted DM frame
'uni|multi' is selecting uni-cast or multi-cast transmission of DM frame
'mep' is the peer MEP-ID of target MEP - only used if 'uni'
'oneway|twoway' is selecting one-way (1DM) or two-way (DMM) DM
'std|prop' is selecting standadized or proprietary DM. the latest is using off-standard follow-up message carrying the exact
HW transmit timestamp
'rdtrp|flow' is selecting round-trip or flow delay calculation. Round-trip is not using the far-end timestamps to calculate the
far-end residence time
'gap' Gap between transmitting 1DM/DMM PDU - in 10 ms.
'count' number of frames used for average calculation on the latest 'count' frames received