6 wiring the digital input / output – PLANET IGS-10020HPT User Manual
Page 42
User’s Manual of IGS-10020PT / IGS-10020HPT
42
2.1.6 Wiring the Digital Input / Output
The 6-contact terminal block connector on the rear panel of IGS-10020PT / IGS-10020HPT is used for Digital Input and Digital
Output. Please follow the steps below to insert wire.
1.
The IGS-10020PT / IGS-10020HPT offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups and 5
and 6 are GND (ground).
Figure 2-6 Wiring the Redundant Power Inputs
2.
Tighten the wire-clamp screws for preventing the wires from loosening.
1
2
3
4
5
6
DI0
DI1 DO0 DO1 GND GND
Figure 2-7 6-Pin Terminal Block DI / DO Wiring Input
3.
There are two Digital Input groups for you to monitor two different devices. The following topology shows how to wire DI0
and DI1.