PLANET IGS-10020HPT - Manual (Page 219)

User’s Manual of IGS-10020PT / IGS-10020HPT
219
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to release the resources required to add QCL entry, incase conflict status for any QCL entry is 'yes'.
: Click to refresh the page immediately.
4.9.13 Queue Policing
This page allows you to configure the Queue Policer settings for all switch ports. The QoS Ingress Queue Policers screen in
Figure 4-9-16 appears.
Figure 4-9-16: QoS Ingress Queue Policers Page Screenshot
The page includes the following fields:
Object Description
• Port The port number for which the configuration below applies.
•
Enable (E) Controls whether the queue policer is enabled on this switch port.
• Rate Controls the rate for the queue policer. The default value is 500. This value is
restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted to 1-3300
when the "Unit" is "Mbps".
This field is only shown if at least one of the queue policers are enabled.
•
Unit Controls the unit of measure for the queue policer rate as kbps or Mbps. The
default value is "kbps".
This field is only shown if at least one of the queue policers are enabled.