PLANET IGS-10020HPT - Manual (Page 284)

User’s Manual of IGS-10020PT / IGS-10020HPT
284
4.12 Security
This section is to control the access of the Industrial Managed Switch, including the user access and management control.
The Security page contains links to the following main topics:
 Port Limit Control
 Access Management
 Access Management Statistics
 HTTPs
 SSH
 Port Security Status
 Port Security Detail
 DHCP Snooping
 DHCP Snooping Statistics
 IP Source Guard Configuration
 IP Source Guard Static Table
 ARP Inspection
 ARP Inspection Static Table
4.12.1 Port Limit Control
This page allows you to configure the Port Security Limit Control system and port settings.
Limit Control allows for limiting the number of users on a given port. A user is identified by a MAC address and VLAN ID. If Limit
Control is enabled on a port, the limit specifies the maximum number of users on the port. If this number is exceeded, an action
is taken. The action can be one of the four different actions as described below.
The Limit Control module utilizes a lower-layer module and Port Security module, which manages MAC addresses learnt on the
port. The Limit Control configuration consists of two sections, a system and a port.
The Port Limit Control Configuration screen in Figure 4-12-1 appears.