PLANET XGSW-28040 - Manual (Page 88)

User’s Manual of XGSW-28040

Link The current link state is displayed graphically. Green indicates the link is up and
red that it is down.

Current Link Speed Provides the current link speed of the port.

Configured Link Speed Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
Auto - Setup Auto negotiation for copper interface.
Auto Fiber (10G) - Setup Auto negotiation for fiber interface.
10Mbps HDX - Force sets 10Mbps/Half-Duplex mode.
10Mbps FDX - Force sets 10Mbps/Full-Duplex mode.
100Mbps HDX - Force sets 100Mbps/Half-Duplex mode.
100Mbps FDX - Force sets 100Mbps/Full-Duplex mode.
1Gbps FDX - Force sets 10000Mbps/Full-Duplex mode.
10Gbps FDX - Force sets 10Gbps/Full-Duplex mode.
Disable - Shutdown the port manually.

Flow Control When Auto Speed is selected on a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used. The Current Rx
column indicates whether pause frames on the port are obeyed, and the Current
Tx column indicates whether pause frames on the port are transmitted. The Rx
and Tx settings are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is related to the
setting for Configured Link Speed.
 Maximum Frame Size Enter the maximum frame size allowed for the switch port, including FCS. The
allowed range is 1518 bytes to 10056 bytes.
 Excessive Collision
Mode
Configure port transmit collision behavior.
Discard : Discard frame after 16 collisions (default).
Restart : Restart back off algorithm after 16 collisions.
 Power Control The Usage column shows the current percentage of the power consumption per
port. The Configured column allows for changing the power savings mode
parameters per port.
Disabled : All power savings mechanisms disabled.
ActiPHY : Link down power savings enabled.
Dynamic : Link up power savings enabled.
Enabled : Link up and link down power savings enabled.
When set each port to run at 100M Full, 100M Half, 10M Full, and 10M Half-speed modes. The
Auto-MDIX function will disable.
88