PLANET XGSW-28040 - Manual (Page 317)

User’s Manual of XGSW-28040
Figure 4-17-1 sFlow Configuration page screenshot
The page includes the following fields:
Receiver Configuration
Object Description

Owner Basically, sFlow can be configured in two ways: Through local management
using the Web or CLI interface or through SNMP. This read-only field shows the
owner of the current sFlow configuration and assumes values as follows:
• If sFlow is currently unconfigured/unclaimed, Owner contains .
• If sFlow is currently configured through Web or CLI, Owner contains
.
• If sFlow is currently configured through SNMP, Owner contains a string
identifying the sFlow receiver.
If sFlow is configured through SNMP, all controls - except for the Release-button
- are disabled to avoid inadvertent reconfiguration.
The button allows for releasing the current owner and disable sFlow
sampling. The button is disabled if sFlow is currently unclaimed. If configured
through SNMP, the release must be confirmed (a confirmation request will
appear).
 IP Address/Hostname The IP address or hostname of the sFlow receiver. Both IPv4 and IPv6
addresses are supported.
 UDP Port The UDP port on which the sFlow receiver listens to sFlow datagrams. If set to 0
(zero), the default port (6343) is used.
 Timeout The number of seconds remaining before sampling stops and the current sFlow
owner is released. While active, the current time left can be updated with a click
on the Refresh-button. If locally managed, the timeout can be changed on the fly
without affecting any other settings.
 Max. Datagram Size The maximum number of data bytes that can be sent in a single sample
datagram. This should be set to a value that avoids fragmentation of the sFlow
datagrams. Valid range is 200 to 1468 bytes with default being 1400 bytes.
Port Configuration
Object Description

Port The port number for which the configuration below applies.
 Flow Sampler Enabled Enables/disables flow sampling on this port.
 Flow Sampler The statistical sampling rate for packet sampling. Set to N to sample on average
317