PLANET XGSW-28040 - Manual (Page 195)

User’s Manual of XGSW-28040
SNAP : Only (SNAP) frames are allowed.
IPv4 : The QCE will match only IPV4 frames.
IPv6 : The QCE will match only IPV6 frames.
 SMAC Displays the OUI field of Source MAC address, i.e. first three octet (byte) of MAC
address.
 DMAC Specify the type of Destination MAC addresses for incoming frame. Possible
values are:
Any : All types of Destination MAC addresses are allowed.
Unicast : Only Unicast MAC addresses are allowed.
Multicast : Only Multicast MAC addresses are allowed.
Broadcast : Only Broadcast MAC addresses are allowedd.
The default value is 'Any'.
 VID Indicates (VLAN ID), either a specific VID or range of VIDs. VID can be in the
range 1-4095 or 'Any'
 PCP Priority Code Point: Valid value PCP are specific(0, 1, 2, 3, 4, 5, 6, 7) or
range(0-1, 2-3, 4-5, 6-7, 0-3, 4-7) or 'Any'.

DEI Drop Eligible Indicator: Valid value of DEI can be any of values between 0, 1 or
'Any'.

Action Indicates the classification action taken on ingress frame if parameters
configured are matched with the frame's content.
There are three action fields: Class, DPL and DSCP.
Class : Classified QoS class.
DPL : Classified Drop Precedence Level.
DSCP : Classified DSCP value.

Modification Buttons You can modify each QCE in the table using the following buttons:
: Inserts a new QCE before the current row.
: Edits the QCE.
: Moves the QCE up the list.
: Moves the QCE down the list.
: Deletes the QCE.
: The lowest plus sign adds a new entry at the bottom of the list of QCL.
4.9.11.1 QoS Control Entry Configuration
The QCE Configuration screen in Figure 4-9-14 appears.
195