RISCO Group LightSYS - Manual (Page 9)

Mastering Your System
Page 9 LightSYS User Manual
Keypad Indication
The LightSYS LCD keypad is the primary system interface and reports its status via its
LCD icons, as described below.
Keypad LCD Icons
Power
On
System is operating properly from AC power, its
backup battery is in good condition and there are no
troubles in the system.
Off No power.
Slow Flash System is being programmed.
Rapid Flash System trouble.
Ready
On System is ready to be armed.
Off System is not ready to be armed
Slow Flash
System is ready to be armed while exit/entry zone is
open.
Arm
On System is armed in Full Arm or Stay Arm mode.
Off System is disarmed.
Slow Flash System is in Exit Delay.
Rapid Flash Alarm condition.
Stay / Bypass
On System is in Stay Arm (Part Set) or Zone Bypass mode.
Off No bypass zones in system.
Tamper
On Zone/keypad/external module has been tampered.
Off All zones are operating normally.
Fire
On Fire alarm.
Off Normal operation.
Flashing Fire circuit problem.
LCD Status Display
The LCD status display will vary depending on the number of partitions in your system.
If your system is defined with only one partition, the LCD displays the partition name,
time and date.
If your system has two or three partitions, the LCD displays the system name, date, time
and the status of each partition. A status letter represents the partition’s status, as follows:
A: Partition Armed N: Partition Not Ready L: Partition in Alarm
S: Partition Stay Armed R: Partition Ready